Special Features:
1.SAFETY: (for 5 minutes). ARMED: 5 minutes after connecting the charge, the indicator light automatically changes from solid green to flashing red. The trap is now armed. CHARGE EXPLODED: If the indicator light is OFF, the mole has been killed. If after a maximum of 2 or 3 days the light is still flashing red, try a different molehill
2.It is a pyrotechnic mole trap that exploits a characteristic behavior of the mole: it systematically backfills any open hole left in its tunnel
3.Working principle. Thanks to its exclusive vertical triggering system, the controller “works every time”. It is based on the blast effect of a charge placed inside the tunnel. When the mole comes to backfill its tunnel, it pushes a plug of earth, which raises the sensor probe and triggers the electrical contact. This causes the explosion inside the tunnel, killing the mole
4.Wide range of application. It can be placed outdoors, garden, yard and courtyard
Using Steps:
1.LEVEL THE MOLEHILL. Clear the chimney (vent hole). Crucially, do NOT backfill it afterwards.
2.PLACING THE CHARGE. Place the unconnected charge into the hole
3.TRAP ON “SAFETY”. Verify that the trap is in the “SAFETY” position
4.INSERT THE TRAP. Insert the trap near the hole, aligned with its axis
5.CONNECTING THE CHARGE. Connect the charge wires to the terminals by pressing the red buttons. You have 5 minutes before the mole eliminator is armed
During CONNECTING THE CHARGE, the indicator light may turn ORANGE temporarily until a continuous contact is established
6.PLACING THE SENSOR PROBE. Clip the sensor probe onto the lever, positioning it at the top entrance of the mole hole (approx. 1 cm inside). It must not touch the bottom. If necessary, bend it so that it aligns with the axis of the hole
7.TO ARM THE TRAP. LIFT THE COVER/HOUSING; pUSH THE TRIGGER IN; rELEASE THE COVER. The trap is now ready to function
8.TO REMOVE THE TRAP. Whether the indicator light is flashing red or is off
Return the trap to the safety position by lifting the cover slightly until the trigger returns to the safety position. You should then hear the characteristic “click”. The indicator light will not change color
9.Important Note: The explosion of the charge does NOT in any way return the trigger to the safety position. Disconnect the charge WITHOUT removing it from the hole. You can then remove the trap
10.When doing this, strictly follow the instructions “TO REMOVE THE TRAP”
